Supply of ten 3100 series IMD, IML ink, ink for the ten 3100 series of two-component low-temperature curing type IMD / IML with the ink. High-temperature drying in general can not be printed on plastic film, suitable for use by the IMD and easy attachment handling PET film, various general products plastic nameplates, polycarbonate (PC) sheet, IMD treatment with PET film by the easy to attach, plastic nameplate. 

 Use 
 Embedded in the requirements for heat and then deal easily molded PET film printing, and ABS, PMMA, rigid PVC, polycarbonate (PC) materials, household appliances, signs like printing. 

 Specialty 
 Around in a wide range of materials can be attached. 
 At 70 ℃ ~ 80 ℃ low temperature curing. 
 Heat resistance, chemical resistance and excellent solvent resistance. 
 For a long time, machine stability and good printing job was good. 

 Use 
 In the FM 100 ink curing agent added 10 to 15, 10 to 30 copies of the solvent, stir after printing. Dilution solvent, solvent use PC (standard, slow dry, slow especially dry). 

 Drying method 
 Standard drying conditions are 70 ℃ 30 minutes or 80 ℃ 20 minutes. Temperatures below this may also be cured, but the drying time will be extended. 
 Tack room temperature (about 10 to 30 minutes), which would need 4 to 6 days to cure, so the recommended method of drying the above conditions. 

 Time of application 
 Room temperature is 30 to 40 hours. For the time after the ink has a mobility sometimes available, but film properties will be low, please avoid using. Time of application because of dilution rate and ambient temperature into the sky changes. 

 Curing catalyst 
 To improve the heat resistance of the ink and solvent resistance, add 2 to 4% of the JAE111 curing catalyst. At this point the application of time becomes shorter. Add volume and applied to the time: 
 Addition of 2% → about 14 ~ 18 hours 
 Addition of 3% → 10 ~ 14 hours 
 4% → addition of about 6 to 10 h 
 Standard color and packaging 
 Standard color: 18 kinds of EXO-color: transparent color 4 5. 1 kg metal cans 
 FM curing agent: 100 grams of metal cans. 
 Curing catalyst JAE111: 50 克 glass bottles.