IMD ink supply INQHF Halogen Empire series, INQHF ink series for the environmental calendar forming two liquid type ink, the raw material not containing halogen (chlorine Cl, bromine Br) compounds, not benzene, toluene, xylene, isophorone and other environmental load substance. It can form a film superior softness, for the injection molding process, also has good heat resistance, especially for the TPU has good adhesion. 
 Use 


 Able to TPU, Easy Bonding PET film, PC film forming on the film calendar logo printed matter production. 
 With the adhesive group and the IMB, with PMMA (acrylic), AS, ABS, PC / ABS resin for the production of injection molding products. 
 Features 


 Raw materials containing no halogen (chlorine Cl, bromine Br) compounds. 
 It is the reaction of two liquid inks, can form a good heat-resistant coating. 
 Note 


 Since halogen-containing compounds may be mixed, it is not specified using the specified solvents and solvent than the curing agent and curing agent. 
 Scraping gum, emulsion and other equipment, be printed, also may contain halogen compounds, so make sure before use. 
 Some of the printing material according to different materials is also necessary for preheating the situation, so before use to confirm. 
 Dilution / mixture of curing agent / detergent 

 Before use, the ink tank to mix before use. 
 Standard dilution solvent is F001 solvent ratio of 15 to 20% added, but according to different printing conditions can use the following solvents. 
 F002 (wicking) F003 solvent (standard) Z705 (slow drying). 
 Too much will dilute the printing performance, decreased adhesion, be sure to be avoided. 
 Add the amount of curing agent the following table: 

 106 curing agent 
 240 curing agent 
 220 curing agent 
 200 curing agent 

 Improve the adhesion to the substrate 
 Increase heat resistance "& @ cr &" Standard (INQ standard) 
 Soft 

 INQHF 
 4% 
 3% 
 5% 
 6% 

 Curing agent can be used time after mixing at room temperature (25 ℃) under the conditions of about 4-5 hours. 
 If more than can be used time and performance degradation will lead to paint, so please do not use. 
 Cleaning: Use a wire mesh detergent (CH) clean print. 
 Auxiliaries SM40 defoamer: To improve the defoaming, leveling, use 1 to 3% ratio. 

 Print 

 Use T200 ~ 270 mesh for screen printing. 
 Mesh screen using the T250, the ink used of approximately 35m2/kg. 

 Drying / curing 

 The need for heating and drying. Use of box-type drying oven, set the conditions of heating at 80 ℃ for 10 minutes, this can be achieved to touch dry. After printing using the IMB adhesives, heat at 90 ℃ for 60 minutes, this is the ultimate dry standard conditions. 
 The printing area, screen mesh