JELCON IMD ink adhesion (old name: 3100 Series FM adhesive ink) is formed or embedded in IMD for forming molded, so that film forming resin and adhesion of the ink pattern. Recommended Use: IMD molded shape formed or embedded as a thin adhesive layer of the printed pattern, as is a single component evaporation drying type ink, the printing job was good. U-1 for ABS materials, the best results. Primarily as a RC-UIM 62 series of ink painting the bottom. Use: ink in the 100 to add 10 to 30 minutes the solvent, stir after the printing. Please use the PC solvent solvent dilution (standard, slow dry, slow especially dry). Drying method: Although at room temperature to dry, but the residual solvent ink film, then, and forming the adhesive resin would be significantly lower, so in the 70 ~ 80 ℃ temperature for 30 minutes to 1 hour of drying.